Bosch KGE39AI30R Цвет Фронт из нержавеющей стали с покрытием AntiFingerPrintбоковые поверхности - chrome-inox-metallic Дисплей и управление на двери прибора - Инструкция (Страница 19)

en
19
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault Possible cause Remedial action
Temperature differs
greatly from the set
value.
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
The light does not
function. Fig. 1/13
Light switch is sticking. Check whether the light switch can
move. Fig. 1/11
The light is defective. See chapter “Light”.
Displays do not
illuminate.
Power failure; the fuse
has been switched off;
the mains plug has
not been inserted
properly.
Connect mains plug. Check whether
the power is on, check the fuses.
The temperature in
the freezer
compartment is too
warm.
Appliance opened
frequently.
Do not open the appliance
unnecessarily.
The ventilation
openings have been
covered.
Remove obstacles.
Large quantities of
fresh food are being
frozen.
Do not exceed max. freezing
capacity.
Appliance is not
cooling, temperature
display and light
are lit.
Showroom mode is
switched on.
Hold down alarm button 2/5 for
10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.