ZELMER 616 - Инструкция (Страница 126)

126
Exhaust air fi lter
The exhaust air fi lter should be replaced upon about 30 hours of operation
(6 months) or earlier in case it gets very dirty.
Press the blockade and open the exhaust cover. –
Replace the fi lter – (1 and 2):
FILTER REPLACEMENT
In the course of the operation the inlet and exhaust air fi lters get dirty. To ensure proper operation of the
vacuum cleaner it is recommended to rinse the inlet fi lter frequently. A very dirty or damaged inlet fi lter has
to be replaced with a new one.
Inlet fi lter
Model: 616.*E – Fig.A – Electrofi lter
Position the new fi lter thoroughly so that the frame edges stick tightly to
the rim of the fi lter.
Model: 616.*S – Fig.B – HEPA Filter cartridge
Upon going though the turbines this foam condenses then on the exhaust fi lter. To avoid this you
should add an anti-foam agent recommended by ZELMER S.A. to the front container and to turn on
the vacuum cleaner (without the front container) for a few minutes to let the suction system dry.
The exhaust air fi lter shall always be replaced with a genuine brand-new one.
Open the upper cover and set it to a vertical position. –
Seize the top edge of the fi lter with your fi ngers and pull it slightly towards you until –
it pulls out from the clamps.
Rotate the frame, take the fi lter out, rinse it with running water wringing it out slightly,
–
dry it and set in place (or replace with a new one).
Position the new fi lter thoroughly so that the frame edges stick tightly to the rim of
–
the fi lter.
Close the cover.
–
instrukcja 616-010.indb 126 instrukcja 616-010.indb 126 2008-09-18 16:03:21 2008-09-18 16:03:21