ZELMER 616 - Инструкция (Страница 124)

124
Wait until the steam cleaning indicator ( – 4) lights up again (indicating that the appliance is ready to
work) and turn on the steam exhaust switch (3).
ATTENTION!!! To avoid cracks on windows, mirrors and other glass surfaces located in cold
(non-heated) rooms and resulting from too big difference of temperature, fi rst heat
these surfaces with a small amount of steam and then begin standard cleaning.
Press the button on the hose grip to adjust the water infl ow to the nozzle. –
The presence of water at the end of the nozzle while starting the stem
cleaning mode is typical.
Move the nozzle on the cleaned area back and forth. The time and intensity of –
cleaning depends on the amount of dirt and the type of the background.
The amount of water in the rear container may be not enough to clean the entire area. Therefore, when
–
all water in the container is used up, refi ll the container, switch on the wet cleaning (detergent) mode
and switch it back to the steam cleaning mode when water appears on the nozzle outlet.
Upon cleaning a part of the fl oor, stop spraying, turn the vacuum cleaner on and suck in the liquid
–
created by condensing steam. To do this move the nozzle slowly towards you until the liquid is removed
from the fl oor. Repeat this operation until the entire surface is cleaned and dries up.
If the three-position switch (1) is set to "1” (steam cleaning) and you want to change it to the “wet
cleaning” mode (“2”), you have to move the switch to the neutral “0” fi rst and then to “2”. Never
switch the three-position switch from “1” to “2” directly.
ATTENTION!!! Never switch the three-position switch from „1” to „2” directly with the omission
of the neutral “0”.
Once you have completed spraying turn off the pump (set the three-position switch ( – 1) to “0” – the
picture on p.3) and press the button on the hose grip to adjust the water fl ow to the nozzle to “release
the pressure”.
Preparation of the vacuum cleaner for steam cleaning
To prepare a saline solution use 3.5l of demineralized (distilled) water with 5g of table salt (1/2 level
teaspoon) or 5 ml of physiological salt (available in drugstores). Do not use salt every time. Use salt to
every third-fi fth water tank.
Do not add salt to tap water.
ATTENTION!!! It is much better to use pure (distilled) water to prevent build-up of scale in the
steam generator.
Put the inlet cap into the slot on the rear container. –
Set the container in place and press it to fi x it fi rmly to the body. –
close the upper cover. –
ATTENTION!!! DO NOT LEAVE THE APPLIANCE READY TO CLEAN (THE STEAM GENERATOR IS
ON) FOR MORE THAN 30 MINUTES.
STEAM CLEANING SMOOTH SURFACES
To use the vacuum cleaner for steam cleaning the glaze, windows, mirrors and other glass surfaces you
should:
attach the steam spray nozzle on the detergent/steam –
extension pipe and lock this joint by turning the blockade,
depending on the amount of dirt fi x the proper insert
–
(collecting or cleaning) to the nozzle.
Set the three-position ( – 1) switch to“1”.
Wait until the steam cleaning indicator ( – 4) is on and turn
on the steam exhaust switch (3) for 5 seconds, which will
then light up.The pressure inside the steam generator
will be released.
After this time turn the switch off.
–
instrukcja 616-010.indb 124 instrukcja 616-010.indb 124 2008-09-18 16:03:20 2008-09-18 16:03:20