ZELMER 616 - Инструкция (Страница 119)

119
In this situation:
Switch the vacuum cleaner off by pressing the main switch and remove the plug –
from the socket.
Turn the hose until the ▼ symbols on the hose and the container are located
–
opposite to each other.Remove the hose from the slot.
Open the upper cover and remove the front container.
–
Take care to wrap the foam fi lter around the fl oat thoroughly (it is fi xed with two fasteners).
Ensure that the gasket sticks to the container tightly. –
Insert the water fi lter into the container –
and place the container on the base.
Close the upper cover. –
Insert the hose into the slot in the container so that the –
▼ symbols on the hose and the container are located
opposite to each other.Turn the hose to the left or right so
that these symbols are displaced.
Connect: –
a. the extension tube and the hose,
b. the extension tube and the nozzle or brush you
want to use.
Insert the plug into the mains socket equipped with an earth pin and start the –
vacuum cleaner by pressing the main switch.
ATTENTION !!! The vacuum cleaner is equipped with a fl oat, which stops
suction automatically when the foam fi lter gets too dirty.This is
demonstrated by an increased rpm of the motor.
Take the water fi lter out of the container and remove the foam –
fi lter.
Clean the fi lters thoroughly (see: “When you have fi nished
–
vacuuming”).
Release the clamp at the bottom of the fi ltration chamber and remove the dust –
collected.
If the dust was previously stored in a paper bag, release the upper cover clamps (
– 1)
as described under p. “A”.
Remove the dirty water from the container and rinse the container. –
Pour clean water, insert the water fi lter, place the container on the base and close –
the upper cover.
Insert the plug into the mains socket equipped with an earth pin, start the vacuum
–
cleaner and continue cleaning.
ATTENTION !!! The fl oat can also stop suction as a result of sudden manoeuvres,
impacts or crossing the doorsteps.
In this situation:
Switch the vacuum cleaner off for a dozen of seconds, then switch it on and continue cleaning. –
instrukcja 616-010.indb 119 instrukcja 616-010.indb 119 2008-09-18 16:03:18 2008-09-18 16:03:18