JVC KS-FX915 EN - Инструкция (Страница 9)

9
ENGLISH
Press ¢ to tune
into stations of higher
frequencies.
F1 F2 F3 AM
(FM1) (FM2) (FM3)
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see “Storing stations in
memory” on page 8.
1
Select the band (FM1 – 3, AM).
2
Select the number (1 – 6) for the preset
station you want.
Other convenient tuner functions
(only for KS-FX815)
Scanning broadcast stations
When you press SCAN while listening
to the radio, station scanning starts.
Each time a broadcast is tuned into,
scanning stops for about 5 seconds
(tuned frequency number flashes on the
display), and you can check what
program is now being broadcast.
7 If you want to listen to that program, press the
same button again to stop scanning.
7
F1 F2 F3 AM
(FM1) (FM2) (FM3)
8 9 10 11 12 7
Press 4 to tune
into stations of lower
frequencies.
Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the FM band
changes as follows:
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
SCAN
Selected band/preset number and
“MEMO” (memory) appear
alternately for a while.
EN07-09.KS-FX915R/815[EE]/f 00.12.12, 5:37 PM 9