17 troubleshooting guide – Инструкция по эксплуатации Sony XR-CA360EE

Страница 17

Advertising
background image

17

Troubleshooting guide

The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connections and operating procedures.

General

Tape playback

Problem

The sound is distorted.

Cause/Solution

The tape head is contaminated.
t Clean the head with a commercially available dry-type

cleaning cassette.

Radio reception

Problem

Preset tuning is not possible.

Automatic tuning is not
possible.

The stations cannot be
received.
The sound is hampered by
noises.

The “ST” indication flashes.

Cause/Solution

•Store the correct frequency in the memory.
•The broadcast signal is too weak.

•The broadcast signal is too weak.

t Use manual tuning.

•The local seek mode is set to ON.

t Set the local seek mode to OFF (page 9).

Connect an power aerial control lead (blue) or accessory power
supply lead (red) to the power supply lead of a car’s aerial
booster. (When your car has built-in FM/AM aerial in the
rear/side glass only.)

•Tune in the frequency accurately.
•The broadcast signal is too weak.

t Set to monaural mode (page 9).

Problem

No sound.

The contents of the memory
have been erased.

Indications do not appear
in the display.

Cause/Solution

•Cancel the ATT function (page 10).
•Set the fader control to the center position for 2-speaker

systems.

•Adjust the volume with (+).

•The power cord or battery has been disconnected.
•The RESET button was pressed.

t Store again into the memory.

•Remove the front panel and clean the connectors. See

“Cleaning the connectors” (page 14) for details.

•The clock display disappears if you press (OFF) for 2

seconds.
t Press (OFF) again for 2 seconds to display the clock.

Problem

The sound skips.

Cause/Solution

A dirty or defective disc.

CD/MD playback

continue to next page t

Advertising