Picture, Sound, Picture sound – Инструкция по эксплуатации Yamaha BD-S671

Страница 85: Hooting” (p. 39), G” (p. 39), Picture ■ sound

Advertising
background image

TROUBLESHOOTING

39

En

ADDITION

AL IN

FORMATION

5

Eng

lish

Picture

Sound

Problem

Possible causes and solutions

No picture.

– Make sure that the cables are connected correctly. (p. 10)
– Make sure that the connected TV or the AV receiver is set to the correct input. (p. 10)
– Connect this Player to the TV with VIDEO jack (p. 13) using the supplied video pin

cable.
– If picture is still not displayed with the unit connected to the VIDEO jack, press and

hold

on the front panel for around 5 seconds when no disc is inserted and

playback is stopped to switch NTSC/PAL and then set Resolution properly. (p. 33).

– TV System is set to the incorrect setting. Press and hold

and

on the front panel

simultaneously when no disc is inserted and playback is stopped to reset the TV System
and Resolution settings to their default settings.

Screen freezes and operation buttons
do not work.

– Press

, then restart playback.

– Turn off the power and turn on the power again.
– Press and hold p on the front panel for around 5 seconds to restart this Player.

Video is not output with the desired
resolution.

– Set to the desired resolution. (p. 33)

Widescreen video appears vertically
stretched, or black bands appear at the
top and bottom of the screen. Or 4:3
video appears horizontally stretched.

– Change the aspect ratio of your TV. (p. 32)

Square noise (mosaic) appears on the
screen.

– Blocks in images may be visible in scenes with rapid movement due to the

characteristics of digital image compression technology.

The playback screen will be disturbed if
DVD video is recorded to a VCR, or
played back through a VCR.

– This Player complies with analog copy protection. Some discs contain a copy

prohibiting signal. If you try to play back such discs through a VCR, or record to a VCR
and play back the signal, the copy protection will prevent normal playback.

Audio is not output, or images are not
played back properly.

– The audio may not be output or the images may not be played back properly for some

discs in which copyright-protected contents are recorded.

Problem

Possible causes and solutions

No sound, or sound is distorted.

– Check that the audio cable is connected correctly. (p. 10)
– Turn the volume of TV or AV receiver up.
– There is no sound during still mode, slow motion playback, fast forward and fast

reverse. (p. 8)

– Audio may not be output depending on the audio recording status, such as when audio

other than an audio signal or non-standard audio is recorded for the audio content. (p. 3)

Left and right channels of audio are
reversed, or sound comes out of only
one side.

– Check the audio connection. (p. 10)

Audio is not output, or images are not
played back properly.

– The audio may not be output or the images may not be played back properly for some

discs in which copyright-protected contents are recorded.

Cannot hear the desired audio type and/
or number of channels.

– Refer to Audio Output setting and “About the audio output formats”. (p. 34, 35)

Cannot hear the sound of PIP
(secondary audio).

– Set Coaxial/Optical or HDMI to PCM/Reencode. (p. 34)
– To hear secondary audio, press 2ND AUDIO. (p. 6)
– Depending on the disc, you may need to set secondary audio on the top menu of the

disc. (p. 8)

Advertising